Indoor TV Antennas

How to Rescan for Channels After Moving Your TV Antenna

After moving your TV antenna, rescan so the TV finds new channels. Set the input to antenna, open the channel setup menu, run the scan, and check the results.

On this page
  1. Short answer
  2. Why rescan
  3. Before you scan
  4. General steps
  5. Tips for better results
  6. If the scan finds nothing, or fewer channels

Short answer

Set your TV to its antenna input, open the channel or broadcast setup menu, and start the automatic scan, which may be called Auto Tuning, Auto Program, Channel Scan or something similar. Wait for it to finish, then check the channel list. You should rescan every time you move the antenna, because the TV only knows about the channels it found the last time it scanned.

Why rescan

  • Moving the antenna changes what it receives. Stations that were too weak before may now come in, and others may drop out.
  • Stations change. Broadcasters sometimes move channels or add subchannels. Consumer Reports recommends rescanning about once a month because you might pick up stations you couldn’t receive earlier.
  • Fresh setups. If you connect an antenna after using cable or streaming, the TV has no stored channels at all.

Before you scan

  1. Place the antenna where you want to test it. See where to place an indoor TV antenna.
  2. Check connections. The coax should be firmly connected to the TV’s antenna port.
  3. Set the input. Antennas Direct advises setting the source to the broadcast, TV or air setting, not cable.
  4. If you have an amplified antenna, make sure it’s powered.

General steps

  1. Press Menu or Settings on the remote.
  2. Find the section for Channels, Broadcasting, Tuner or Setup.
  3. Choose Antenna (or “Air”) as the signal type, if asked.
  4. Select Auto Tuning, Auto Program, Channel Scan or Scan for Channels.
  5. Let the scan complete. It can take a few minutes.
  6. Open the channel list or guide and check what was found.

Menu names differ by brand and model year, and even with the same brand, so use your TV’s manual or the on-screen search. Antennas Direct notes that each television is different and procedures vary. For a brand-specific example, see connecting an indoor antenna to a Samsung smart TV.

Tips for better results

  • Scan at each test position. If you’re trying several spots, rescan each time and note the channel count.
  • Watch for stability, not just counts. A channel listed in the scan can still break up. See antenna pixelating or breaking up.
  • Check whether the scan adds or replaces. Some TVs keep old channels after a new scan; some have an option to clear the channel list first. If old, dead channels linger, look for a clear or reset option in the same menu.
  • Expect subchannels. One station can carry several digital subchannels, which appear as numbers such as 7.1, 7.2.
  • Rescan occasionally even if you don’t move the antenna.

If the scan finds nothing, or fewer channels

If your TV is older than about 2007, it may lack a digital tuner and need a converter box, as Antennas Direct notes. For a broader view, see our indoor TV antenna guide.

The complete guide to indoor tv antennas

Indoor TV Antennas: How to Choose One That Actually Works
Read the guide

Keep exploring

Guides from other topics

All topics →