Realistic expectations
A homemade indoor antenna can work, especially if you live close to the transmitters. It’s a cheap project and teaches you how antennas behave. It is unlikely to beat a good commercial outdoor antenna, and “long range” is a stretch for any indoor antenna. If you’re far from the towers, check your signal first with the tools in how to find out which channels you can get.
This guide covers a common design called the multi-bowtie. It’s a UHF-focused antenna. Many US stations broadcast on UHF, but some are on VHF, which a small bowtie won’t receive well. Check your local station list before you start.
What you need
- A piece of wood or plastic board to mount the elements (about 2 feet by 1 foot is typical; non-metal).
- Bare or insulated copper wire, or coat hangers cut into equal lengths.
- A 75-ohm to 300-ohm matching transformer (balun), the small adapter sold for connecting twin-lead antennas to a coaxial TV input. These are inexpensive.
- Screws and washers for connection points.
- A length of coaxial cable (RG6 or similar) with an F connector.
- Wire cutters, a drill or screwdriver, and a ruler.
A simple bowtie build
Dimensions below are typical for a UHF bowtie; they are a starting point, not a precision spec.
- Cut eight pieces of wire, each roughly 14 to 15 inches long, for a four-bay bowtie (two arms per bay).
- Shape them into “V” or bowtie arms, so each bay forms two triangular halves that nearly touch at the center.
- Mount the arms on the board in two columns, with a gap of about 1 to 2 inches at the center of each bowtie so the two halves don’t touch.
- Connect the center points of all bays with a wire (a zigzag pattern) so the halves feed in phase, finishing at two terminals at the middle of the board.
- Attach the balun at those two terminals. The coax then runs from the balun to your TV.
Details vary among designs; the design matters less than neat connections and keeping the two halves of each bowtie electrically separate. If your balun uses screw terminals, a washer under each screw can help make a solid connection.
Wiring and matching to the TV
TV antenna inputs are typically 75-ohm coax. Bowtie antennas have a higher impedance, so the balun matters; without it, signal loss can be significant. Keep the coax run short and avoid sharp bends.
Can coax cable act as an antenna?
Technically, the exposed center conductor of a coaxial cable can pick up some signal, and people sometimes strip a cable end and plug it into the TV as an emergency antenna. It’s unlikely to be reliable, but it may work in strong-signal areas. A dedicated antenna design generally performs better.
Placement and testing
- Connect it to the TV and set the input to antenna.
- Run a channel scan. See how to rescan for channels.
- Move it around: a window facing the towers, higher on the wall, away from metal. See where to place an indoor TV antenna.
- Rescan each time you move it and compare channel counts and stability.
Improving it
- Try a different position or orientation before changing the design; placement often matters more.
- Add a reflector (a piece of metal screen behind the bowtie) to make it more directional. This helps if all towers are in one direction.
- Try an amplifier only if you’ve tested without it. See amplified indoor antennas.
If you’re wondering whether a TV antenna can double as a Wi-Fi antenna, see can a TV antenna be used for WiFi. Nor is there a legitimate way to get satellite TV for free from a homemade antenna; satellite signals require a dish and a service.
When to buy instead
If a homemade antenna doesn’t give you reliable reception, a commercial model is the next step, and it may come with returns. Start with our guide to choosing an indoor TV antenna, or consider an attic installation.