Outdoor TV Antennas

Can you test an antenna with a multimeter?

Can you test an antenna with a multimeter? Yes for basic continuity and shorts, no for signal strength or impedance. Here's what it can and can't tell you.

On this page
  1. Short answer
  2. What a multimeter can tell you
  3. What it can’t tell you
  4. A basic continuity check
  5. Checking coax
  6. Amplified antennas: be careful
  7. Better ways to test reception

Short answer

A multimeter can help you find certain physical faults in an antenna or its cable, such as a break or a short. It cannot tell you how well the antenna receives signals, and it cannot measure RF impedance or gain.

What a multimeter can tell you

A multimeter measures things like voltage, current and DC resistance. That is useful for:

  • Continuity. Whether a conductor is intact from one end to the other.
  • Shorts. Whether the center conductor of a coax cable touches the shield.
  • Power on amplified antennas. Whether DC power is reaching the amplifier or preamp.

What it can’t tell you

  • Signal strength or quality. For that, use your TV’s signal meter, a tuner’s diagnostic screen or a dedicated signal meter.
  • Impedance. Some pages suggest measuring an antenna’s “impedance” by reading resistance with a multimeter. That does not work: the 75-ohm (or 300-ohm) figure for a TV antenna system describes how the system behaves at radio frequencies, not what a DC resistance reading shows. A reading in the ohms range does not confirm the antenna is matched.
  • Gain or pattern. Those depend on the shape and layout of the antenna. See is a high gain antenna better.

A basic continuity check

  1. Disconnect the antenna from the TV and from any power supply.
  2. Set the meter to continuity (beep) or a low resistance range.
  3. Check the connector’s center pin to the far end of the element or balun where it is accessible. Your reading depends on the design, since some antennas are DC-open and others (such as folded dipoles) are DC-closed, so compare against the manufacturer’s information or a known-good identical antenna.
  4. Look for an unintended short between center and shield.

Checking coax

Touch one probe to the center pin at one end and the other to the center pin at the other end: you should see continuity. Then check between center and shield at one end: for a plain cable, you should see an open circuit. Wiggle the connectors during the test, since intermittent faults are common outdoors.

Amplified antennas: be careful

Amplifiers and preamps are powered through the coax or a separate injector. Do not poke around a live circuit, and do not probe with the power connected unless you know the voltage and your meter’s range. If you suspect a failed amplifier, replace the unit or test it as the manufacturer instructs.

Better ways to test reception

A channel scan is the most useful test, along with signal-strength and quality readings on the TV. Try temporary positions and aim changes, using height and obstructions as your main variables. For VHF issues specifically, see VHF TV antennas.

The complete guide to outdoor tv antennas

Long-Range Outdoor TV Antennas: A Buyer's Guide
Read the guide

Keep exploring

Guides from other topics

All topics →