A standard dipole is a single half-wave conductor split at the centre and fed there. A folded dipole is the same length but made as a closed loop of two parallel conductors, with the feed in the middle of one of them. The result is a similar radiation pattern, about four times the feed impedance and a wider bandwidth.
Construction
- Dipole: two quarter-wave legs, one on each side of the feed point. The total length is about 468 divided by the frequency in MHz, in feet.
- Folded dipole: a half-wave conductor with a second conductor running parallel to it and joined at both ends, forming a long thin loop. The feed point is cut into the middle of one conductor.
Impedance and feed
A simple dipole in free space has a feed impedance around 70 ohms, and real installations commonly land between 50 and 75 ohms, which suits 50 ohm coax directly (often via a 1:1 balun). A folded dipole’s impedance is about four times higher, in the region of 300 ohms. That is why it is traditionally fed with 300 ohm twin-lead or with a 4:1 or 6:1 balun when connecting to 75 or 50 ohm coax.
Bandwidth
The folded design has a broader useful bandwidth, meaning SWR stays low across a wider slice of the band. This is useful on bands where you want to operate over a large frequency range or when you do not want to retune.
Pattern and gain
The radiation pattern is essentially the same figure-eight as a regular dipole, with little or no difference in gain. Folding does not make the antenna more powerful; it changes impedance and bandwidth.
Which should you use?
- Regular dipole: the best default for HF. It is simple, light and cheap, and easy to build and trim. See how long a 40 meter dipole should be.
- Folded dipole: good when you value bandwidth or need a high impedance, for example as the driven element of a Yagi or on VHF/FM broadcast reception.
Read about the benefits and the disadvantages of folded dipoles for more detail, or HF delta loops and broadband folded dipoles for the broadband HF versions.