FM Radio Antennas

What is a dipole antenna?

A dipole antenna is a simple two-element antenna fed at the centre, most often cut to half a wavelength. Learn how it works, its variants and where dipoles are used.

On this page
  1. Short answer
  2. How a dipole is built
  3. How it works
  4. Radiation pattern
  5. Common variants
  6. Where dipoles are used
  7. Strengths and limits
  8. Dipoles for FM

Short answer

A dipole antenna is a simple antenna made of two equal conductors, typically two lengths of wire or rod, with a feed line connected at the centre between them. In its most common form, the half-wave dipole, the total length is about half the wavelength of the signal you want to send or receive. It is one of the oldest and most widely used antenna designs.

How a dipole is built

  • Two conductors in a straight line, each roughly a quarter wavelength long.
  • A small gap at the centre, where the feed line connects.
  • One conductor goes to each side of the feed line: for coax, one half to the centre conductor and the other to the braid.
  • Insulators at the ends and centre to support it.

That is all. Many receivers use a dipole in the form of a T-shaped wire. For the practical cutting lengths and build steps, see FM dipole antennas: how they work and how to make one.

How it works

A passing radio wave pushes electrons back and forth in the conductors. When the antenna length matches the wave closely, that motion builds up into a relatively strong signal at the feed point, so the dipole responds best near its design frequency. The same principle works in reverse for transmitting, which is why antennas are generally reciprocal: a good receiving antenna is generally a good transmitting antenna, and vice versa.

The length depends on frequency. A common approximation is a total length in feet of about 468 divided by the frequency in MHz. That works out to under 5 feet for the FM broadcast band, but a much longer wire for lower frequencies such as shortwave.

Radiation pattern

A horizontal dipole is most sensitive at right angles to the wire (broadside) and has nulls, or weak points, off the ends. In three dimensions the pattern looks like a doughnut around the wire. It follows that how you orient the dipole matters: point the broad side toward the stations you want.

Common variants

  • Half-wave dipole: the standard version described above.
  • Folded dipole: a looped conductor with a higher impedance (about 300 ohms), commonly made from twin-lead and used for FM and TV reception. It also tends to cover a wider range of frequencies.
  • Inverted-V: the two legs slope downward from a central high point. Useful when there is only one high support.
  • Sloper and vertical dipole: orientations used where space is tight.
  • Multiband dipoles: such as fan dipoles, trap dipoles or doublets, which cover more than one frequency band.

Where dipoles are used

Dipoles are used in many places:

Strengths and limits

Strengths: cheap, simple, easy to build, predictable behaviour and good reliability.

Limits: modest gain, a figure-eight pattern that may point in the wrong direction, and a length that scales with wavelength. For weak-signal or long-range FM listening, a Yagi usually does better; see FM DX antennas.

Dipoles for FM

A simple dipole is one of the best-value upgrades for FM reception, particularly if your current antenna is a short piece of wire. Placement matters as much as the design, so see our FM radio antenna guide for placement and connector advice, and 75 ohm vs 300 ohm FM antenna connections if you are unsure how to connect it to your receiver.

The complete guide to fm radio antennas

FM Radio Antennas: Indoor vs Outdoor and What to Buy
Read the guide

Keep exploring

Guides from other topics

All topics →