Is an attic install right for you?
An attic antenna sits under the roof, so it stays dry, out of sight and out of the wind, and the install is much safer than working on a roof. The tradeoff is some signal loss, since the roof, insulation and building materials sit between the antenna and the tower. In areas with strong or moderate signals, an attic is often enough. Where signals are weak or you are far from the towers, an outdoor mount usually does better. See how to install an outdoor TV antenna.
Start by checking which stations you should be able to receive and from which direction, using the FCC’s DTV Reception Map or a similar tool.
What can block attic reception
- Metal roofs block or heavily reduce TV signals. If you have one, an attic is generally not a good choice.
- Foil-faced insulation or radiant barrier under the roof deck can block signal as well.
- Wet or heavy materials, such as wet insulation, concrete or clay tile, and stucco with metal mesh, weaken signals.
- Large HVAC ducts, wiring and metal framing near the antenna can affect reception.
- Distance and terrain, as with any antenna.
A quick test is to try the antenna in the attic temporarily and run a channel scan before you do a permanent install.
Safety in the attic
- Step only on joists or on boards laid across them. The ceiling drywall will not support your weight.
- Attics can be very hot in warm weather, so work in the cooler part of the day and take breaks.
- Wear a mask, gloves and eye protection if there is insulation or dust.
- Use a good light, and watch out for nails, wiring and insulation.
- Do not work near exposed electrical wiring, and stay out of the attic during storms.
- Keep a helper nearby if possible.
Tools and parts
- An attic-rated or outdoor TV antenna and its mounting hardware
- RG6 coax, connectors and clips (see RG6 vs RG59 coax for a TV antenna)
- A drill and bits, screws or brackets, a compass, a flashlight
- A fish tape or string for pulling cable through walls or openings, if needed
Step-by-step
- Choose a location. Pick a spot as high as practical in the attic, close to the roof peak or on the side facing the towers, with a clear view and away from metal ducts, wiring and large metal objects.
- Assemble the antenna following the manual.
- Mount it securely to a rafter or a stable beam, using the supplied bracket and screws. The antenna should not be able to shift or fall. Make sure it can turn if you plan to re-aim it.
- Orient it toward the main tower direction using your compass. Keep the antenna in the orientation specified by the manufacturer.
- Run the coax from the antenna to where you will connect it to the TV. You can route it down through an existing cable opening, a wall cavity or along a path that does not damage anything. Do not run coax tightly alongside power wires, and do not kink it.
- Connect to the TV, set it to antenna input, and run a channel scan.
- Adjust the aim, scan again, and repeat until the channels you want come in best. See how to align an antenna and how to aim and align a long-range TV antenna.
- Fix it in place once you are happy with the result.
Since you may need to go back and forth between the attic and the TV, a helper, a phone or walkie-talkie, or a rotator can save a lot of time.
Grounding
Antennas fully inside the attic and under the roof are generally treated differently from outdoor masts, but rules vary. Check the instructions for your antenna and your local code. If any part of the antenna is outdoors or on the roof, see how to ground a TV antenna mast and protect it from lightning.
More than one TV
You can split the signal to several TVs, though each split reduces the signal. See how to split a TV antenna signal to multiple TVs. With an attic antenna, signal is often already reduced, so an amplifier may help; see how to install a TV antenna amplifier.
Troubleshooting
- Few channels: Check the roof and insulation for metal, try another location in the attic, and re-aim.
- Channels come and go: Wet roofing, trees in leaf and weather can change reception. Check connectors.
- Pixelation: Try a shorter cable, better connectors or an amplifier only if the signal is weak.
- Interference: Keep the antenna away from electronics and wiring. See TV antenna interference from Wi-Fi and how to fix it.
When to move the antenna outdoors
If you cannot get the channels you want after trying several attic positions, or if you have a metal roof or foil insulation, mounting the antenna outside, higher and with a clearer path, will usually give better results.