End-fed HF antennas are popular because they are simple to hang: one wire, one transformer, one support. Models sold for “6 m to 80 m” coverage, such as the HFEDZ, promise a lot from a single wire. This page explains the principle behind them and what to check before relying on a multiband claim.
What an end-fed half-wave is
An end-fed half-wave (EFHW) is a wire about half a wavelength long on its lowest band, fed at one end rather than the centre. A half-wave wire has a high impedance at its end, often in the low thousands of ohms, which is far from the 50 ohms your rig and coax expect. That is why these antennas need a matching device at the feed point.
The matching transformer
The transformer, often called an unun, steps that high impedance down to something close to 50 ohms. Ratios around 49:1 are common for half-wave designs, but check the specific product rather than assuming. The quality of the transformer matters: core material, winding and power rating decide how much power is lost as heat and how flat the match is across bands.
How one wire covers many bands
A wire that is a half-wave on its lowest band is also close to a whole number of half-waves on multiples of that frequency, and the impedance at its end stays high on each of them. A wire cut for 40 m, for instance, behaves reasonably on 20 m, 15 m and 10 m. A longer 80 m wire adds the lower bands. Bands that are not simple multiples, such as 30 m or 17 m, may need a tuner or additional loading.
What an “80 m to 6 m” model implies
A true half-wave on 80 m is around 40 m (about 130 ft) long. Products offering 80 m to 6 m in a much shorter package must be using some combination of loading coils, traps, a shortened radiator or reliance on an ATU. I do not have verified manufacturer details on how the HFEDZ achieves its coverage, so confirm three things on the listing or manual:
- which bands are resonant and which need a tuner;
- the rated power for SSB, CW and digital modes;
- the total wire length you actually have to fit.
Expect shortened versions to be less efficient on the lowest bands than a full-size wire.
Installation
- Keep the wire as straight as practical. Sharp bends and proximity to metal change tuning.
- Raise the feed point and wire as high as you safely can, clear of trees, gutters and power lines. Never run a wire where it could fall on, or be blown into, power cables.
- Support the far end with a non-conductive rope and insulator.
- Run the coax away from the wire at right angles for a few metres where possible.
- Use a common mode choke at or near the feed point.
Common-mode current and noise
An end-fed has no balanced feed and typically no true counterpoise, so the outside of the coax often becomes part of the antenna. This is why many EFHW users see high noise, RF in the shack or SWR that changes when they touch the cable. A choke on the coax, and choosing a length of coax that avoids resonant lengths on your main bands, can help. Some designs include a short counterpoise wire; follow the maker’s guidance.
Power, heating and limits
Transformers heat up on sustained high-duty modes like FT8, RTTY or AM. Stay well inside the rated power, keep digital-mode power modest, and check the unit is not hot after a long transmission. Rated figures for small transformers are often for short-duty SSB.
Measuring it
Check the match with an antenna analyzer rather than relying on the rig’s built-in meter. Understand that a good SWR on one band does not mean the antenna radiates efficiently there. If your rig has an ATU, see whether you need an antenna tuner.
When to choose something else
If you need quiet reception, a magnetic loop or delta loop may be better. If you want proven low-angle performance and have little space, consider a multiband vertical. See the HF antenna overview for other options.