For most vertical antennas, radials are cut to about a quarter of a wavelength on the band you use. That is the standard answer for elevated radials. For radials lying on or just above the ground, the exact length matters less than how many you lay, so many shorter radials are usually better than a few long ones.
The quarter-wave rule
A quarter wavelength in feet is roughly 234 divided by the frequency in MHz. Some examples:
| Band | Approx. quarter wave |
|---|---|
| 80 m (3.6 MHz) | about 65 ft (20 m) |
| 40 m (7.1 MHz) | about 33 ft (10 m) |
| 20 m (14.2 MHz) | about 16.5 ft (5 m) |
| 10 m (28.5 MHz) | about 8 ft (2.5 m) |
Wire radials in practice are often cut slightly longer than the calculation and trimmed if the design calls for resonant radials, since insulation and height affect length.
Elevated versus ground-level radials
- Elevated radials (a metre or more above ground) behave like a proper counterpoise. They should be resonant, around a quarter wave, and a small number, often two to four per band, can work well.
- Ground-mounted radials are coupled to lossy soil. Their exact length is less critical, and the main goal is to cut ground losses by covering the area under the antenna with many radials.
How many radials?
More is better, with diminishing returns. A common guide for a ground-mounted quarter-wave vertical is to use as many as you can, with a typical target of 16 or more for a serious permanent installation, and fewer if you accept some loss. For portable or temporary use, a handful is acceptable. One DX Commander user, for example, uses 4 m radials in four bunches and notes that more radials improve efficiency, though results on a hill were still good with four.
Short and shared radials
You can use a shorter radial than a quarter wave on a given band, but it will not be resonant, so efficiency drops and the SWR may shift. On multiband verticals with a single radial set, using a mix of lengths for the lower and higher bands or a longer set cut for the lowest band is typical.
Radial-free antennas
Some products advertise that they do not need radials, such as certain end-fed verticals with a transformer at the base. These still need a return path, which will be the ground or the coax shield. If you see odd SWR or noise, a common mode choke may help, as discussed in our multiband vertical guide.
Checking your work
Measure SWR with an antenna analyzer before and after adding radials; a large drop in SWR or a rise in signal reports is a sign the radials are helping. If you only listen, see the best vertical for listening to HF radio, where radials matter less. For other vertical choices, see our HF antenna guide.