To install a UHF radio antenna, choose a high, clear location, mount the antenna firmly (on a metal ground plane for a vehicle, or on a mast for a fixed station), connect it with the shortest practical run of good coax, and check the SWR before you operate. The details differ for vehicles and fixed installations.
Choose the antenna and location
UHF wavelengths are short, so a quarter-wave antenna is only about 16 to 17 cm (around 6.5 in) at 450 MHz. See VHF/UHF mobile antennas for how different antenna designs compare. The two rules that matter most:
- Height and clearance. UHF is largely line of sight, so mount the antenna as high as you reasonably can, clear of obstructions.
- A ground plane for quarter-wave and 5/8-wave antennas. On a vehicle, the metal roof or body is that ground plane. Mounting at the roof centre gives the most even pattern.
Installing on a vehicle
- Choose the mount type. Roof or trunk-lip mounts, a bull-bar or bracket mount, or a magnetic mount for temporary use.
- Plan the coax route. Run cable along the body seams or under trim to the radio without crushing or kinking it. Leave a small drip loop or sealed pass-through where it enters the vehicle.
- Prepare the surface. For a magnetic mount, clean the roof so the magnet sits flat. For a bolt-on mount, make sure the contact area is bare metal and check for sharp edges.
- Fit the antenna. Screw it on firmly and avoid over-tightening. Put a bit of weatherproofing on exposed connectors.
- Connect and test. Connect to the radio and check SWR (see below).
Avoid mounting at the very edge of the roof or on a plastic panel without a proper ground plane. Antenna mounting mistakes, such as poor grounding or placing it behind metal, are a common cause of high SWR.
Installing a fixed base antenna
- Choose the position. A mast or pole above the roofline, away from metal objects, trees and other antennas.
- Mount the mast. Use brackets rated for the load and wind. Do not use a mast near power lines. If you can’t be sure a fall would clear overhead wires, don’t put it up there.
- Attach the antenna. Follow the maker’s instructions on orientation, which is usually vertical for omnidirectional antennas.
- Run low-loss coax. On UHF, coax losses rise quickly with length, so use good coax and keep the run as short as possible.
- Weatherproof connections. Use self-amalgamating tape or boots on outdoor joints.
- Ground and protect. Follow local guidance on grounding and lightning protection for masts and cables.
Check the SWR
Use an SWR meter or antenna analyzer on the frequencies you use. Readings under about 1.5:1 are generally considered good and under 2:1 usually acceptable, but see what a good SWR is for caveats. If it is high, check the connectors, the ground contact and the coax before moving the antenna.
Common mistakes
- Putting the antenna too low or beside metal obstructions.
- Using cheap, long coax.
- Poorly crimped or soldered connectors, or water getting into the cable.
- Skipping the SWR check.
Safety
Keep antennas and masts well away from power lines. Do not transmit with people near the antenna, and use sensible power levels. If you are not comfortable working at height, get help.