Ham Radio Antennas

What are the disadvantages of folded dipole antennas?

The main drawbacks of folded dipole antennas: a high feed impedance that needs matching, extra wire and weight, limited multiband use and loss in terminated versions.

On this page
  1. A high feed impedance needs matching
  2. More wire, more weight
  3. Not truly multiband
  4. Terminated versions waste power
  5. Build and cost
  6. When these downsides do not matter

The main disadvantages of a folded dipole are that its feed impedance is much higher than that of a plain dipole, so it needs a matching balun or transformer; it uses more wire and is heavier; it does not work as a simple multiband antenna; and broadband terminated versions burn off some of your power. Whether these matter depends on what you want from the antenna.

A high feed impedance needs matching

A simple half-wave dipole presents roughly 50 to 75 ohms at its centre, depending on height and environment. A folded dipole has about four times that, in the region of 300 ohms. To use it with ordinary 50 ohm coax you need a balun or transformer, commonly a 4:1 or 6:1 type, which adds cost, a possible point of failure and a little loss. Classic designs are fed with 300 ohm twin-lead, which is why they suit older TV and FM setups.

More wire, more weight

A folded dipole is a loop of two parallel conductors rather than a single wire, so there is more material to hang and more wind loading. Heavier wire plus spacers can sag, and the structure needs more support than a simple wire dipole. Multi-wire models for broadband use, such as the Yaesu YA-30 (about 83 ft long), are larger and heavier than a single-wire dipole for the same band.

Not truly multiband

A folded dipole can be used on its odd harmonics, but its impedance and pattern change, and you may need a tuner. Unlike a trap dipole or a fan dipole, it does not cleanly cover several amateur bands. If you want to cover several bands, you will usually need another design or a tuner. See end-fed HF antennas or multiband verticals for alternatives.

Terminated versions waste power

Broadband designs such as the T2FD add a resistor to make the impedance flat over a wide range. That resistor absorbs part of the transmitted power as heat. One supplier notes that a dipole cut for a specific band can outperform this kind of broadband antenna. Power ratings on commercial versions are also relatively modest. More on this in HF delta loops and broadband folded dipoles.

Build and cost

Building a good one requires careful spacing, matched legs and a good balun. Commercial models cost more than a simple dipole kit. Tuning also takes more care because the two conductors interact.

When these downsides do not matter

If you want a single-band, wide-bandwidth antenna and have the supports, the disadvantages are modest. See the benefits of a folded dipole and how a folded dipole differs from a regular dipole. For a simple, efficient baseline, see how long a 40 meter dipole should be.

The complete guide to ham radio antennas

HF Antennas for Ham Radio: Choosing the Right Type
Read the guide

Keep exploring

Guides from other topics

All topics →