Ham Radio Antennas

What Is a Good SWR for a Ham Antenna? Reading and Lowering It

A good SWR for a ham antenna is usually under 1.5:1, and up to 2:1 is acceptable. What the numbers mean, what causes high SWR and how to lower it.

On this page
  1. What SWR means
  2. A rough guide
  3. SWR is not efficiency
  4. Where you measure
  5. Common causes of high SWR
  6. How to lower it
  7. Meter or analyzer?

For most ham radio use, an SWR of 1.5:1 or lower is considered good, and up to about 2:1 is generally acceptable. Above about 3:1, many transmitters start reducing their power to protect themselves. A low SWR means your antenna system is a good match for the transmitter; it does not by itself mean the antenna is efficient.

What SWR means

SWR (standing wave ratio) measures how well the impedance of your antenna system matches the impedance your transmitter expects, usually 50 ohms. A perfect match is 1:1. When there is a mismatch, part of the power is reflected back toward the radio.

A rough guide

SWR Approx. power reflected Comment
1.0:1 0% Ideal
1.5:1 about 4% Very good
2:1 about 11% Usually fine
3:1 about 25% Many rigs begin to reduce power; use a tuner
5:1 and higher high Investigate; can stress the rig

These figures are for power reflected at the point of measurement. Some of that reflected power is then re-reflected by the transmitter’s output stage, and the real loss is usually smaller than the table suggests, particularly with low-loss coax. The bigger issue is that the transmitter may reduce power, or in a poor design could be damaged.

SWR is not efficiency

A dummy load has a perfect SWR and radiates nothing. A very lossy antenna, or a feedline with high loss, can also show a lovely SWR because the losses hide the mismatch. A low reading is necessary but not sufficient evidence for a well-performing antenna. Conversely, a resonant antenna with SWR of 2:1 may work better than a heavily loaded short one at 1.1:1.

Where you measure

Measure at the transmitter end for what the rig sees, but remember that long, lossy coax makes the SWR look better than it is at the antenna. If you are trimming or troubleshooting, measure as close to the antenna as possible. See how to use an antenna analyzer.

Common causes of high SWR

  • An antenna that is too long or short for the frequency.
  • Poor connectors, water in the coax or a damaged cable.
  • A missing or poor ground, counterpoise or radial system. See vertical radials.
  • Common-mode current on the coax shield, which makes readings change when you touch the cable. See common mode chokes.
  • Nearby metal objects or trees detuning the antenna.

How to lower it

  1. Check connections and cable for obvious faults.
  2. Sweep the band to see where the antenna is resonant.
  3. Trim or extend the antenna, a little at a time. See dipole length and trimming.
  4. Add or improve radials or a counterpoise on verticals.
  5. Add a choke.
  6. If you cannot get it low on every band, consider an antenna tuner.

Meter or analyzer?

An SWR meter shows the reading while you transmit at one frequency. An analyzer shows the curve across a band with no real transmission. For setting up or fixing antennas, an analyzer saves a lot of time. For basics see our HF antenna guide.

The complete guide to ham radio antennas

HF Antennas for Ham Radio: Choosing the Right Type
Read the guide

Keep exploring

Guides from other topics

All topics →